KELLY-MOORE PAINT CO INC -- SUPER LATEX FLAT WALL PAINT ALL COLORS, 550  -- 8010-00N036377
<pre>=====================  Product Identification  =====================

Product ID:SUPER LATEX FLAT WALL PAINT ALL COLORS, 550
MSDS Date:05/30/1986
FSC:8010
NIIN:00N036377
MSDS Number: BQQXB
=== Responsible Party ===
Company Name:KELLY-MOORE PAINT CO INC
Address:1015 COMMERCIAL ST
City:SAN CARLOS
State:CA
ZIP:94070
Country:US
Info Phone Num:415-592-8337
Emergency Phone Num:800-424-9300(CHEMTREC)
Preparer's Name:JOE SCARRY
CAGE:KELLY
=== Contractor Identification ===
Company Name:KELLY-MOORE PAINT CO INC
Address:1015 COMMERCIAL ST
City:SAN CARLOS
State:CA
ZIP:94070
Country:US
Phone:415-592-8337
CAGE:KELLY

=============  Composition/Information on Ingredients  =============

Ingred Name:PROPIONIC ACID, 2-METHYL-, MONOESTER WITH
    2,2,4-TRIMETHYL-1,3-PENTANEDIOL; (TEXANOL). VP:0.04 @ 68F.
CAS:25265-77-4
RTECS #:UF6000000
Fraction by Wt: <5%

Ingred Name:MAY CONTAIN PIGMENTS (INGS 4 - 8) THAT MAY BE NUISANCE DUST
    HAZARDS IN THEIR ORIG DRY POWDER FORM, NOT HAZ IN WET PAINT.
RTECS #:9999999ZZ

Ingred Name:TITANIUM OXIDE; (TITANIUM DIOXIDE)
CAS:13463-67-7
RTECS #:XR2275000
OSHA PEL:15 MG/M3 TDUST
ACGIH TLV:10 MG/M3 TDUST; 9293

Ingred Name:SILICATES
CAS:14407-96-6

Ingred Name:CALCIUM CARBONATE; (MARBLE), (LIMESTONE)
CAS:1317-65-3
RTECS #:EV9580000
OSHA PEL:15 MG/M3 TDUST
ACGIH TLV:10 MG/M3 TDUST

Ingred Name:SILICON DIOXIDE (AMORPHOUS)
CAS:67762-90-7

Ingred Name:BARIUM METABORATE MONOHYDRATE
CAS:13701-59-2

Ingred Name:PHENYLMERCURIC ACETATE; (PAINT PRESERVATIVE) (SARA
    III).(ING 9 OR 10 TO CTL MICROORGANISMS @ LEVELS NOT CONSIDERED
    HAZ).
CAS:62-38-4
RTECS #:OV6475000
OSHA PEL:0.1 MG/M3 (HG), C, S
ACGIH TLV:0.01 MG/M3 (HG)
EPA Rpt Qty:100 LBS
DOT Rpt Qty:100 LBS

Ingred Name:3,5,7-TRIAZA-1-AZONIAADAMANTANE, 1-(3-CHLOROALLYL)-,
    CHLORIDE; (PAINT PRESERVATIVE)
CAS:4080-31-3
RTECS #:XX8450000

Ingred Name:ETHYLENE GLYCOL  (SARA III). VP:0.1 @ 68F.
CAS:107-21-1
RTECS #:KW2975000
Fraction by Wt: <5%
OSHA PEL:50 PPM, C
ACGIH TLV:50 PPM, VAPOR, C
EPA Rpt Qty:1 LB
DOT Rpt Qty:1 LB

=====================  Hazards Identification  =====================

LD50 LC50 Mixture:NONE SPECIFIED BY MANUFACTURER.
Routes of Entry: Inhalation:YES  Skin:YES  Ingestion:YES
Reports of Carcinogenicity:NTP:NO    IARC:NO	OSHA:NO
Health Hazards Acute and Chronic:ACUTE:DIZZINESS, HEADACHE, NAUSEA,
    CONFUSION, IRRITATION TO UPPER RESPIRATORY TRACT, UNCONSCIOUSNESS,
    SKIN & EYE IRRITATION. CHRONIC:NONE KNOWN.
Explanation of Carcinogenicity:NOT RELEVANT
Effects of Overexposure:SEE HEALTH HAZARDS.
Medical Cond Aggravated by Exposure:SEE YOUR MD FOR SPECIFIC MEDICAL
    OPINION REGARDING YOUR CONDITION.

=======================  First Aid Measures  =======================

First Aid:INHAL:REMOVE TO FRESH AIR. RESTORE BREATHING. CONSULT MD.
    EYE:FLUSH W/LARGE VOLUMES OF WATER FOR AT LEAST 15 MINUTES. GET
    MEDICAL ATTENTION. SKIN:WIPE OFF W/RAG. WASH THOROUGHLY W/SOAP &
    WATER. INGEST :CONSULT HOSPITAL, EMERGENCY ROOM OR POISON CONTROL
    CENTER IMMEDIATELY.

=====================  Fire Fighting Measures  =====================

Flash Point:>200F,>93C
Extinguishing Media:MEDIA SUITABLE FOR SURROUNDING FIRE .
Fire Fighting Procedures:WEAR NIOSH/MSHA APPROVED SCBA & FULL
    PROTECTIVE EQUIPMENT .
Unusual Fire/Explosion Hazard:CLOSED CONTAINERS MAY EXPLODE (DUE TO
    BUILD-UP OF STEAM PRESSURE) WHEN EXPOSED TO EXTREME HEAT.

==================  Accidental Release Measures  ==================

Spill Release Procedures:VENTILATE AREA TO PREVENT BUILD-UP OF VAPORS.
    FOR SMALL SPILLS, SOAK UP W/ABSORBENT. FOR LARGER SPILLS, DIKE AREA
    W/ABSORBENT MATERIAL & SCOOP UP LIQUIDS.
Neutralizing Agent:NONE SPECIFIED BY MANUFACTURER.

======================	Handling and Storage  ======================

Handling and Storage Precautions:STORE UPRIGHT IN SEALED CONTAINERS
    AWAY FROM HEAT & FLAME.
Other Precautions:NONE SPECIFIED BY MANUFACTURER.

=============  Exposure Controls/Personal Protection  =============

Respiratory Protection:USE NIOSH/MSHA APPRVD PARTICLE MASK TO AVOID
    BRTHG SPRAY MIST/SANDING DUST IF LOC VENT IS ADEQ TO KEEP TLV W/IN
    ACCEPT LIMS. IF LOC VENT IS NOT ADEQ, THE USE OF NIOSH/MSHA APPRVD
    RESP FOR ORG VAP, SUP PLIED AIR/SCBA EQUIP IS RECOM.
Ventilation:LOCAL EXHAUST SUFFICIENT TO KEEP TLV BELOW PRESCRIBED
    LIMITS.
Protective Gloves:IMPERVIOUS GLOVES .
Eye Protection:CHEMICAL WORKERS GOGGLES .
Other Protective Equipment:NONE SPECIFIED BY MANUFACTURER.
Work Hygienic Practices:REMOVE & WASH CONTAMINATED CLOTHING BEFORE
    REUSE.
Supplemental Safety and Health
NONE SPECIFIED BY MANUFACTURER.

==================  Physical/Chemical Properties  ==================

HCC:N1
Boiling Pt:B.P. Text:212F,100C
Vapor Pres:SEE INGS
Vapor Density:LTR/AIR
Evaporation Rate &amp; Reference:SLOWER THAN ETHER
Appearance and Odor:NONE SPECIFIED BY MANUFACTURER.
Percent Volatiles by Volume:60-70

=================  Stability and Reactivity Data  =================

Stability Indicator/Materials to Avoid:YES
STRONG OXIDIZING AGENTS.
Hazardous Decomposition Products:MAY PRODUCE HAZARDOUS FUMES WHEN
    HEATED TO DECOMPOSITION AS IN WELDING.

====================  Disposal Considerations  ====================

Waste Disposal Methods:DISCARD IN LANDFILL IN SEALED METAL CONTAINERS
    AWAY FROM HEAT & FLAME & I/A/W LOCAL, STATE & FEDERAL REGULATIONS.

 Disclaimer (provided with this information by the compiling agencies):
 This information is formulated for use by elements of the Department
 of Defense.  The United States of America in no manner whatsoever,
 expressly or implied, warrants this information to be accurate and
 disclaims all liability for its use.  Any person utilizing this
 document should seek competent professional advice to verify and
 assume responsibility for the suitability of this information to their
 particular situation.